new
or
You are here : Stone Home > Info Center > STONEBTB News > Put an Edge on a Mosaic Table

Put an Edge on a Mosaic Table

Updated:2013-10-08 15:07:31
Mosaic table tops add a feeling of individuality and creativity to any room. The individualized patterns are created by placing very small tiles, pieces of cut glass, stones, metal, or even beads in a predetermined pattern. The mosaic material sits on the surface of the table. Add an edge to the mosaic table to prevent damage to the mosaic material. Edging is made from wood trim, veneer, metal or plastic. The edging is secured to the table edge using small finishing nails and/or wood glue.

Instructions as follows:

                                                       

Firstly, measure the height of the table edge including the height of the mosaic. Determine the width of the flat wood trim for purchase. Add a minimum of 3/4 inches to the depth of the mosaic tile to ensure enough wood is present for securing to the table edge. Purchase the determined width of 1/4-inch flat wood trim.
Secondly, measure the table edge lengths. Add 1/2 inch to each length. Write down the measurements.
Thirdly, turn the 1/4-inch flat wood trim on edge. Mark the edge of the trim at the predetermined lengths. Allow the width of the saw blade when marking the edge of the wood.
Fourthly, hold the trim on edge against the inside edge of the miter box. Cut the trim at a 45 degree angle.
Fifthly, sand the cut edges of the trim. Remove all splinters and burrs.
Sixthly, stain or paint the front side and the edges of the cut trim to match the table edge. Allow the stain or paint to dry for 30 minutes. Apply a layer of sealer if the wood is stained. Allow the sealer to dry for 30 minutes.
Seventhly, apply a thin line of glue down the middle back of each cut trim board.
Eighthly, center the trim board over the appropriate table edge. Allow 1/4-inch of each end to stick past the edge of the table. Hammer finish nails 1/4-inch below the mosaic tile line. Place the nails 12 inches apart. Repeat the process on all sides. The 1/4-inch overlap will miter together when all pieces are in place.
Ninthly, tap the heads of the nails 1/16-inch into the wood.
Tenthly, apply colored wood putty in each nail hole.
Premium Related Products
Rosso Levanto
Rosso Levanto
Price:Negotiation
Origin:Turkey
Categories:Granite
XIAMEN FANCY NATURAL STONE CO.,LTD.
ChinaChina
Royal Sanna
Royal Sanna
Price:Negotiation
Origin:Italy
Categories:Marble
XIAMEN FANCY NATURAL STONE CO.,LTD.
ChinaChina
Roye Botticino
Roye Botticino
Price:Negotiation
Origin:Iran
Categories:Marble
XIAMEN FANCY NATURAL STONE CO.,LTD.
ChinaChina
Browse by: Stone Manufacturers | All Products | For Buyers | For Sellers | Suppliers | Stonebtb.com International | Stonebtb.com China | Site Map
About Us | Stonebtb Service | Contact Us | Our Partners | Video | Exchange Link | Terms of Use
Copyright 2007-2018 Stonebtb.com All rights seserced